威尼斯电子游戏(5848VIP认证)官网-Global NO.1

• Compatible with NXP e500MC core

• Native support for multiprocessor systems

• 32KB instruction CACHE, 32KB data CACHE

• 128KB L2 CACHE

• MMU support

• 1MB L3 Cache

• Supporting public key cryptographic algorithms and symmetric cryptographic algorithms

• Supporting national cipher algorithm of SM2/SM3/SM4/SM9

• Supporting international algorithms of RSA/AES/DES/SHA

• Supporting reconstructed algorithms

• Temperature detection

• Voltage detection

• Frequency detection

• True random number generator with maximum output data rate of 20M

• Supporting 64-bit data + 8-bit for ECC data

• Supporting 8-bit and 16-bit data width

• Supporting up to 800MHz, 1.6GT/s

• Compatible with PCI-E 3.0

• Supporting X4 connection, can be used in RC or EP mode

• Compatible with RapidIO 2.2 and backward compatible with RapidIO 2.1/2.0/1.3/1.2/1.1

• Supporting DMA operation

• Supporting USB3.0 high-speed standard and OTG function

• Supporting point-to-point transfer with a high-speed, full-speed, or low-speed USB device

• Supporting Session Request Protocol (SRP) and Host Negotiation Protocol (HNP)

• Supporting Suspend and Resume low power control

• Supporting DMA access to FIFO

• Supporting 10G-BASE-KR mode, compatible with 10G-BASE-R through parallel detection

• 10G-BASE-KR mode supports FEC error correction

• Supporting 4-CH sending and receiving engine

• 16KB Rx FIFO and 16KB Tx FIFO

• Supporting 2 10GE Ethernet interfaces

• Supporting 10/100/1000Mbps half-duplex or full-duplex Ethernet access

• Used in various Ethernet application scenarios

• Power management

• Different packet processing characteristics

• Supporting 8 1GE Ethernet interfaces

• Complied with SATA3.0 standard, backward compatible with SATA 1.0 and 2.0

• Supporting 4 channels

• Supporting high-speed DMA based on descriptors

• Supporting 8 ROM, EPROM, SRAM, Flash or peripheral chip selection

• Supporting Burst and non-Burst transmission

• Supporting 8-bit and 16-bit

• Programmable access time for each device

• Supporting serial master mode operation

• Supporting DMA controller interface

• Supporting enhanced SPI

• Supporting SD3.0 and 3.01 specifications, including eSD

• Supporting SDIO 3.0, including eSDIO

• Optional 16 or 64-byte FIFOs for sending or receiving data

• Programmable baud rate, data bits, parity check, and stop bits

• Supporting DMA access

• Compatible with Philips Semiconductor I2C standard

• 2 independent 4*1byte data buffers

• Detecting illegal start and stop signals

• Power domain: 0.9V, 1.0V, 1.5V, 1.8V, 3.3V

• Packaging: CBGA1295

• Supporting master/slave mode operation

• SPI operation can be controlled in Doze mode

• Programmable data frame size from 4-16bits

• Supporting time calibration in high-speed transmission mode